How to Replace the Inspire Built-In Speaker
Welcome to ENYA MUSIC Workshop 206. In this guide, we’ll show you how to replace the built-in speaker module on your Inspire. Before starting, make sure the backplate and circuit board have already been removed.
Before Starting
If you haven’t removed the backplate and circuit board yet, follow our previous Workshop guides:
How to Swap Enya Inspire's Battery
Learn how to remove the Inspire backplate and disconnect it from the guitar.
How to Swap the Inspire Tailjack PCB
Follow this guide to remove the circuit board and access the speaker module.
#1 Remove Screws
Start by unplugging the speaker connector from the PCB. You’ll see five screws secured by rubber grommets around the speaker module. Use a Phillips-head screwdriver to remove all five screws, and keep them organized for reassembly.
Once all five screws have been removed, gently apply a little pressure to remove the entire speaker module.
#2 Swap Speaker
Place the new speaker module into position and reverse the removal process. Tighten the five screws to secure the module, then reconnect the speaker connector to the PCB.
Once the speaker module is installed, reinstall the circuit board and backplate to complete the replacement.
Final Check
Make sure the speaker module is securely fastened and the speaker connector is properly connected to the PCB. Once everything is back in place, your Inspire is ready to play.
Watch the Complete Replacement Process
Follow the video below for a visual walkthrough of the complete speaker replacement process.
How to Replace the Inspire Built-In Speaker | ENYA MUSIC Workshop 206
Next Up
In Workshop 207, we will cover How to Replace the Inspire Pickup Selector Switch. Stay tuned for the final guide in the Inspire replacement series.